Wear-resistant flooring may also chalking, surprisingly, because of these 2 reasons

Diamond wear-resistant flooring is a type of flooring with high wear resistance and hardness, which can be divided into two types, one of which is non-metallic and the other is metallic. The other type of diamond wear-resistant flooring all have their own advantages, you can choose freely according to the actual demand situation.

First, diamond wear-resistant flooring chalking reasons.

1. Insufficient cement grade or content of ground concrete.

2. Diurnal maintenance of macadamite wear-resistant flooring is not enough.

Second, diamond wear-resistant ground chalking preventive measures

1, flooring before construction and construction team and contractor to communicate well, strive to avoid because of the cement label or content of the flooring caused by insufficient chalking.

2, emery wear-resistant flooring used raw materials to choose good, can not choose inferior materials.

3, after construction, can't just no matter, regular maintenance is still essential.

Special emphasis, in addition to the above-mentioned macadamite wear-resistant flooring appear chalking reasons, unreasonable construction steps is also caused by its chalking another reason.

Three, avoid diamond sand wearable flooring appear chalking phenomenon to do the following construction attention points.

First, pour and tamp the concrete base, the selected concrete grade should be no less than 25. Then use power trowel and disc to further smooth the base layer to ensure the concrete surface is flat and dense. When the concrete first set, start to spread the hardener, at the same time, use the power trowel plus disc to compact and smooth again.

Second, after the completion of the first step about 1 to 2 hours later, and then fill the operation of spreading hardener and compaction; and finally use the power trowel plus the blade for polishing seal. At the same time to repair the concrete layer of the corners of the part; Finally, spray curing agent or cover the film, to prevent the rapid evaporation of cement caused by ground cracking. All operations, from levelling the concrete layer to covering the film with curing film, should be completed within 24 hours, and can be opened for walking 2 to 3 days after the completion of construction. You can also use a ride on power trowel to smooth out the macadam or concrete, both of which can make the construction perfect.

Wear-resistant flooring construction looks simple, but do up a lot of details to pay attention to, if you are not careful, the quality of the whole project will collapse, it is recommended to try a small piece to see the effect, the effect is good and then large area construction to avoid causing big losses.